Laser Engraved, Laser Cut on the Elegoo Phecta
My friends cpu was stuck to his heatsink, here are the steps we took
– tapped on it sideways with a hammer and a screwdriver to spin it off carefully
-had bent pins (not due to the hammer, but because it came out / transport to my house) used a razor to go between the rows, swiping with the flat part near the end to get it mostly there
– printed a loose -0.058mm kerf piece on circular scap I had sitting around
-printed a slightly tighter -0.060mm kerf piece on more scrap (could be tighter)
take note that my laser is calibrated pretty well and the beam width/radius (no clue which) is .060mm
and you can either have a smaller piece or you can have a thin piece of loose fabric to raise the cpu off of the surface to more accuratly only adjust from the far end of the pins.
Reviews
There are no reviews yet.